13. Remove the six Torx T8M2.5×7.0 screws (1) that secure the panel to the enclosure.
NOTE: If tape secures the panel to the enclosure, lift the tape to disengage the panel from the
enclosure.
14. Lift the top of the display panel, and then remove the panel from the enclosure (2).
15. If you need to remove the display hinge brackets from the display enclosure:
NOTE: Display hinge brackets are available in the Hinge Kit using spare part number
733634-001.
a. Remove the four Phillips PM2.0x3.0 screws (1) that secure the display panel to each hinge.
b. Remove the hinge brackets from the display panel (2).
88 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
