b. Separate the bracket from the hard drive (2).
Reverse this procedure to reassemble and install the hard drive.
Solid-state drive (SSD) – mSATA
Description Spare part number
128 GB 737343-001
32 GB 737342-001
Before removing the solid-state drive module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 46).
5. Remove the service door (see
Service door on page 48).
Remove the solid-state drive:
1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the drive to the computer.
Component replacement procedures
51
To Next Page
Loading...
