Start Here: Installation, Safety, and Regulatory Information
6
CAUTION:
OnlyHPE Aruba Networking-approved power cords may be used with HPE Aruba Networking devices.
To access power cord information for your switch, see the latest edition of the HPE Aruba Networking
CX 6200F/M Installation and Getting Started Guide. Lost or damaged power cords must be replaced only
with HPE Aruba Networking-approved power cords. If your installation requires a different power cord
than the one supplied with the switch, be sure that the cord is adequately sized for the current
requirements of the switch. In addition, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country/region. The mark is your assurance
that the power cord can be used safely with the switch.
CAUTION:
Do not use a damaged or non-recommended power cord with your switch. Using such power cords voids
the switch warranty. It can also cause serious electrical problems, including injury or death to personnel,
and damage to the switch and other property. If you cannot verify that you have a power cord approved
for use with your switch model, contact your authorized HPE Aruba Networking dealer or sales
representative for assistance.
WARNING:
Remove the power cord from the switch before mounting or dismounting the switch.
Japan power cord warning
CAUTION:
FOR INDOOR USE ONLY. The switch, power cords, and all connected cables are not designed for outdoor
use.
Brazil Statement
Este equipamento deve ser conectado obrigatoriamente em tomada de rede de
energia elétrica que possua aterramento (três pinos), conforme a Norma NBR
ABNT 5410, visando a segurança dos usuários contra choques elétricos.)
CAUTION: Shock hazard. To completely remove power from the switch,
disconnect all power cords.
Environmental specifications
To Next Page
Loading...
