Configuring Spare settings
Procedure
1. From the System Utilities screen, select System Configuration > HPE Smart Array P824i-p MR
Gen10 > Main Menu > Controller Management.
2. In the Controller Management screen, select Advanced Controller Properties .
3. In the Advanced Controller Properties screen, click Spare to configure the Spare settings.
4. In the Spare screen, enable or disable the following settings:
• Persistent Spare - the option to have the system backplane or the storage enclosure drive slots
dedicated as spare slots. If enabled, the replacement of a spare drive in the same slot will
automatically configure the drive as a spare.
• Replace Drive - the option to copy data from a spare drive to a drive.
• Replace Drive on SMART Error - the option to start a Replace operation if a SMART error is
detected on a drive.
5. Click Apply Changes.
Configuring Task Rates
Procedure
1. From the System Utilities screen, select System Configuration > HPE Smart Array P824i-p MR
Gen10 > Main Menu > Controller Management.
2. In the Controller Management screen, select Advanced Controller Properties .
3. In the Advanced Controller Properties screen, click Task Rates to configure the Task Rates.
4. In the Spare screen, configure the following task rates:
• Background initialization (BGI) Rate - the percentage of system resources dedicated to perform a
background initialization on a redundant logical drive.
• Consistency Check Rate - the percentage of system resources dedicated to perform a consistency
check operation on a redundant logical drive.
• Patrol Read Rate - the percentage of system resources dedicated to perform a Patrol Read
operation on configured drives.
• Rebuild rate - the percentage of system resources dedicated to rebuild data on a new drive after a
storage configuration drive has failed.
• Transformation Rate - the percentage of system resources dedicated to perform a RAID level
migration or online capacity expansion on a logical drive.
5. Click Apply Changes.
Configuration 49
To Next Page
Loading...
