Interfaces
57
User Manual
Figure 55: Using 4.5W Modules on Ports 49, 50, 55, 56 in SN2410M/SN2410bM
3.1.1.1 Supported Passive Cables in SN2010M
• For server ports:
• 25GbE cables (all ports can be used):
• 1m-1.5m: any DAC
• 2m: MCP2M00-A002E30N
• 2.5m: MCP2M00-A02AE26N
• 3m: MCP2M00-A003E26N
• 10GbE cables (all ports can be used):
• 0.5m to 5m: any DAC
• For IPL ports (SN2010M to SN2010M connection):
• 40/100GbE cables (all ports can be used):
• No limitations
• 25GbE cables (only ports 3, 6, 9, 12, 15, 18 can be used)
• Up to 2m: any DAC
• 10GbE cables (all ports can be used):
• 0.5m to 5m: any DAC
• For connections with other switches:
• AOCs/Transceivers only
Figure 56: Supported 25GbE and 40/100GbE Cables on IPL Ports (SN2010bM to SN2010bM Connection)
3.1.2 Speed
Ethernet speed must be set manually. The system’s ports can be manually configured to run at
speeds ranging from 10GbE to 100GbE (for more details, see
“Specifications”). To change the
port speed configuration, use the command “speed” under interface configuration mode. Refer to
the MLNX-OS User Manual for instructions on port speed re-configuration.
4.5W
4.5W
4.5W
4.5W
Up to 1.5W
Up to 1.5W
Up to 1.5W
Up to 1.5W
4.5W
4.5W
4.5W
4.5W
Up to 1.5W
Up to 1.5W
Up to 1.5W
Up to 1.5W
To Next Page
Loading...
