HPE StoreFabric SN6600B

Transceiver
type
Speed Multimode
media (50
microns)
(OM2)
Multimode
media (50
microns) (OM3)
Multimode
media (50
microns) (OM4)
Single Mode
Media (9
microns)
32 Gb/s N/A 70 m (230 ft) 100 m (328 ft) N/A
LWL 4 Gb/s N/A N/A N/A 30 km (18.6
miles)
8 Gb/s N/A N/A N/A 10 km (6.2 miles)
10 Gb/s
1
N/A N/A N/A 10 km (6.2 miles)
16 Gb/s N/A N/A N/A 10 km (6.2 miles)
32 Gb/s N/A N/A N/A 10 km (6.2 miles)
ELWL 4 Gb/s N/A N/A N/A N/A
8 Gb/s N/A N/A N/A N/A
10 Gb/s
1
N/A N/A N/A N/A
16 Gb/s N/A N/A N/A N/A
32 Gb/s N/A N/A N/A N/A
1
Supported by HPE StoreFabric SN6600B 32Gb FC Switch only
Memory specifications
Table 10: Memory specifications for the HPE StoreFabric SN3600B 32Gb FC
Switch and HPE StoreFabric SN6600B 32Gb FC Switch
Memory type Size
Boot flash 8 MB
eUSB Module 2 GB
Main memory (DDR2 SDRAM) • HPE StoreFabric SN3600B 32Gb FC
Switch-2 GB, 64-bit
• HPE StoreFabric SN6600B 32Gb FC
Switch-4 GB, 64-bit
FC port specifications
The FC ports are compatible with SWL, LWL, and ELWL SFP+ transceivers. The strength of the signal is
determined by the type of transceiver in use.
The FC ports meet all required safety standards. The ports operate at 4, 8, 16, or 32 Gb/s, depending on
SFP+ models, and are able to autonegotiate to the maximum link speed.
34 Memory specifications