NOTE:
The SN3600B Rack Mount Kit contains rails labeled Left and Right to designate the left side
and right side of the device or cabinet as viewed from the front of the cabinet.
5. Assemble the outer rails as follows:
• Attach the left outer rail and right outer rail to the rear mounting brackets using two 1/4-20 hex
nuts with captive star lock washers attached loosely, as shown in HPE 10000 Series Rack. Do
not tighten the nuts.
Figure 3: HPE 10000 Series Rack
• Depending on the rack you are using, complete one of the following tasks:
◦ For an HPE 10000 Series Rack, install two #10-32 x 1/2-inch Phillips panhead screws with
captive star lock washers and two #10 adapter washers in the upper and lower holes on the
right rail. Then, install two #10-32 x 1/2-inch Phillips panhead screws with captive star lock
washers and two #10 adapter washers in the upper and lower holes on the left rail. (See HPE
10000 Series Rack).
Setup and install 9
To Next Page
Loading...
