HPE StoreOnce 5200

• The power button LED flashes green at the start of the power-on sequence and then turns solid
green.
• The system health LED flashes green at the start of the power-on sequence and then turns solid
green.
• If LAN port 1 is connected to an active link, the NIC status LED will also begin to flash green
when the StoreOnce System is powering up.
• While configuring the system using iLO virtual console, the UID LED flashes blue.
1
2
3
4
Item Description
1 Power LED and on/off button
2 NIC status LED
3 System health LED
4 UID LED
8. Connect the network.
If the system is not connected to a network with DHCP, configure iLO during bootup.
If the system is connected to a network with DHCP, iLO will work without additional configuration.
Most iLO settings must be configured during bootup. The iLO network options can also be configured
with the System Manager.
a. Press F9 System Utilities.
b. Navigate to System Configuration > iLO 5 Configuration > Network Options.
c. Configure the iLO network options and note the details.
iLO IP address:___________________________
iLO subnet mask:_________________________
iLO gateway:_____________________________
12 HPE StoreOnce 3620 System