HPE StoreOnce 5200

• The initial DHCP configuration fails.
• The StoreOnce System is in an environment without DHCP.
This procedure results in a basic network configuration with a single address.
Procedure
1. Access the Initialization Console.
2. Select Configure initial network.
3. Select either Configure static (IPv4 or IPV6) address or Configure dynamic address.
When configuring a static address, enter the network configuration parameters. When configuring a
dynamic address, select the protocols.
4. Click OK.
Resetting the local Admin password
This procedure resets the password for the local Admin user to admin, which forces a password change
at the next log in.
This password reset only applies to systems using local authentication. This procedure does not affect
LDAP or Active Directory users.
Procedure
1. Access the Initialization Console.
2. Select Reset admin password.
3. Click OK.
4. Once the reset has been applied, navigate to the StoreOnce Management Console in a new browser
tab to be presented with the password dialog.
Changing the Initialization Console password
The Initialization Console password can also be changed from the StoreOnce Management Console in
the Security area.
Procedure
1. Access the initialization console.
2. Select Change console password.
3. Enter the current and new passwords.
4. Click OK.
Enabling support access
A support engineer can obtain the information used to generate the temporary support password from the
Initialization Console. Accessing the support access feature is only required if the StoreOnce
Management Console is inaccessible. For more information about using and generating temporary
support passwords, see the user guide.
The Initialization Console 143