Newly detected storage is added to the storage list with a status of Unconfigured.
d. To configure the new storage for use, expand the Actions ( ) menu and select Configure.
10. Configure Remote Support using STaTS.
For additional information, see StoreOnce Remote Support.
11. Configure Fibre Channel.
For additional information, see Fibre Channel with StoreOnce Systems.
12. Configure iLO, if necessary.
If you plan to use iLO with the system and did not configure it during the system installation,
configure iLO now.
• View or update the iLO configuration from the StoreOnce Management Console.
a. On the main menu, select Settings.
b. In the Hardware section, click the Integrated Lights Out (iLO) Configuration panel.
The Integrated Lights Out (iLO) Configuration screen shows the HPE Integrated Lights Out
network configuration.
• In environments that do not use DHCP, DNS, or WINS, configure a static IP address during
bootup.
a. Restart or power on the StoreOnce Server.
b. Press F9 in the server POST screen.
The UEFI System Utilities start.
c. Navigate to System Configuration > iLO 5 Configuration > Network Options.
d. Configure the iLO network options and note the iLO IP address, iLO subnet mask, and iLO
gateway.
13. The StoreOnce 3620 System is now installed and ready for production use.
Installing the StoreOnce 3620 Capacity Upgrade Kit
The system comes with six 4 TB disks already installed in the left six disk bays numbered 1, 2, 5, 6, 9,
and 10; the remaining disk bays are filled with blanking plates.
The capacity upgrade kit contains six 4 TB disks that you will install in the right six disk bays numbered 3,
4, 7, 8, 11, and 12.
NOTE: All six disks in the capacity upgrade kit must be installed before you can expand storage.
Figure 2: Disk bays populated before expansion
16 HPE StoreOnce 3620 System
To Next Page
Loading...
