HPE StoreOnce 5200

4. Install the StoreOnce server in the rack.
a. Install the rail kit for the StoreOnce server. See the installation instructions supplied with the rail
kit.
b. Insert the two locking nuts for the server into the rack; one on each front column.
c. Install the server into the rack and secure it using the thumbscrews on the front bezel of the
server.
5. Connect the StoreOnce server.
a. Connect the power cables.
Connect each power cable to a separate PDU in the rack.
b. Connect a network cable to LAN port 1.
c. Connect a network cable to the iLO port (recommended).
d. Connect a VGA monitor and a USB keyboard for initial configuration.
6. Attach the security bezel to the front of the server.
a. Insert the security bezel right tab into the slot on the chassis and then rotate the bezel to close.
HPE StoreOnce 3640 System 23