HPE StoreOnce 5200

7. Fit the storage enclosure into the rack.
CAUTION: Use extreme caution when installing and pulling units from the rack. Unattached
units can slip and fall, damaging the StoreOnce System or causing personal injury. Hewlett
Packard Enterprise is not responsible for any damage or injury caused by mishandling the
StoreOnce System.
Always use at least two people to lift and locate an enclosure into the rack.
a. Check the JBOD pull-out tab in the upper left corner of the rear panel of the storage enclosure.
The base enclosure is labeled "JBOD1". If the system has multiple storage enclosures, verify that
you are installing the base enclosure.
b. Slide the base enclosure into position on the rails (1). Secure the chassis into the rack by
tightening the captive CTO screw behind the latch on the front left and right bezel ears of the
chassis (2).
CAUTION: The front CTO screw must be attached at all times when racked.
HPE StoreOnce 5200 System 43