2. Slide the enclosure into position on the rails (1). Secure the chassis into the rack by tightening the
captive CTO screw behind the latch on the front left and right bezel ears of the chassis (2).
CAUTION: The front CTO screw must be attached at all times when racked.
CAUTION: Use extreme caution when installing and pulling units from the rack. Unattached units
can slip and fall, damaging the StoreOnce System or causing personal injury. Hewlett Packard
Enterprise is not responsible for any damage or injury caused by mishandling the StoreOnce
system.
Always use at least two people to lift and locate an enclosure into the rack.
3. Attach rear hold down brackets by sliding the tab with the arrow pointed forward (1) into the
corresponding slot on the left and right side of the rear of the chassis. Use the black headed thumb
screw to secure tightly to the rail (2).
80 Installing capacity upgrade kits
To Next Page
Loading...
