Ignoring the following instructions may cause battery overheating, fire, explosion, damage and/or
performance, and reduced product life.
1.Be sure to use the provided battery and power charger. Do not disassemble the printer to install
uncertified batteries as doing so may result in a fire, explosion, or damage to the printer.
2.Do not allow any liquids to enter or leak onto the battery. If the battery’s internal safety mechanism
is affected, charging the battery may result in overheating, a fire, or an explosion.
3.Keep the battery away from the stove or other high temperature sources. Excess heat may damage
the resin cover or insulation materials and short-circuit the battery, resulting in overheating, burns, or
an explosion.
4.Use the provided USB Type-C cable to charge the printer to avoid overcharging and abnormal
currents or voltages, which may result in overheating or an explosion.
5.Keep the battery away from any heat or fire source as it may compromise the safety of the battery
and result in overheating, burns, or an explosion.
6.Do not throw or physically abuse the battery as it may compromise the safety of the battery while
charging and result in overheating, burns, or an explosion.
7.The liquid in the battery is corrosive. If improper operation causes the battery to leak, wash it off/out
with water and consult a medical professional, if necessary.
To Next Page
Loading...
Need help?
General
