46
Troubleshooting
Machine does not start:
• Emergency stop?
• Cable OK?
• Full voltage in all phases?
• Error message on the display?
• Cable OK?
• Speed setting? Not on the highest.
The machine shuts down often:
• Reduce speed.
• Error message on the display?
• Cable OK?
• Full voltage in all phases?
The machine sways or does not run smoothly on the floor.
• Check the grinding holders.
• Check the upper belt.
• Check the tools/wear.
• The screws that fasten the grinding head to the chassis may be too tight.
The tools wear unevenly (more than 3mm difference):
• Overhaul the grinding holders.
To Next Page
Loading...
