HTC 650 HDX - Safety

7
Safety
The machine may only be operated or repaired by personnel who have undergone practical or theoretical training and
have read through this manual.
The instructions in this manual must be observed in order for CE marking to apply.
Only use the machine for grinding or polishing unhewn stone, terrazzo, concrete or any other ooring material specied in
this manual.
Do not use the machine in environments where there is a risk of explosion or re.
Wear personal protective equipment at all times - safety boots, hearing protectors, protective goggles and protective glo-
ves.
Do not start the machine in the folded position. Only start the grinder with the rotating disks facing the oor and with the
tools applied.
Be careful when replacing grinding tools as the tools and metal disks can be hot.
Disconnect the power supply from the machine when replacing the grinding tools.
Only lift the machine using the parts specied in this manual.
Do not use the machine on sloping surfaces.
Do not move the machine manually on sloping surfaces as there is a major risk of crushing if the machine starts to roll.
Always fold up the machine when removing glue or wet grinding so that the machine does not get stuck to the oor and
damage machine parts upon restart.
Always keep the machine in a dry and warm area when it is not being used.
If the machine is kept in a cold area, it must stand in a heated room for two hours prior to use.
Only use the machine with the splashguard installed.
Use only HTC original tools and genuine spare parts.