HTC 800 RX - On Delivery; Unpacking the Machine

HTC 800 RX Introduction
2.0 3
The machine can also be moved short distances using the inbuilt battery drive and with
the support wheel fitted. The battery capacity is sufficient to transport the machine for
ca. 30 minutes.
Do not transport the grinder on sloping surfaces, e.g. loading ramps, without securing it
by the lifting eyes, , position 4, Figure3-1, page10for example with a winch. This is
a safety measure in case the grinder starts to roll out of control. Also make sure that
people (including operator) in the vicinity are at a safe distance in order to prevent
personal injury, in the event that the grinder starts to roll out of control.
1.5 On delivery
The following items are included in the delivery. Contact your retailer if anything is
missing.
• Grinding machine
• Manual
• Locking key for control cabinet
• Start key
• Hammer EZ system
• Support wheel for transport
• The radio control unit
1.6 Unpacking the machine
Warning!
Read through the safety instructions and the manual carefully before use.
• Check carefully to see if the packaging or machine has been damaged during
delivery. If there is any sign of damage, contact your retailer and report it. Report
packaging damage to the transport company as well.
• Check that the delivery matches the order. If there are any discrepancies, contact
your retailer.
• When lifting the grinder, lifting straps must be used. These must be attached
well-secured in the lifting eyes provided, position 4, Figure3-1, page10. Only
use lifting straps approved for lifting equipment.