HTC 800 RX - Locking the Wheels

HTC 800 RX Usage
2.0 17
3. Make sure that the handle lock returns to the original position to guarantee that
the handle is locked properly.
Figure 4-2. The handle's position
1. Working position - always used when operating manually. It can also be used
when driving via the radio control unit.
2. Rear position - used for tipping the machine in order to make changing tools
easier. It can also be used to advantage when driving the machine via the radio
control unit.
3. The forward position - used, for instance, for transportation, as the machine takes
up significantly less space.
Lock the handle in the desired position, using the handle lock, seeFigure4-1, page
16.
4.3 Locking the wheels
The machine is equipped with a locking mechanism on each wheel, see the driving lock
in Figure3-2, page11. The driving lock is used to release and decouple the machine's
wheels from their drive motors, which are located in the drive motor box,
seeFigure3-2, page11. In the locked position, the drive motors are connected to the
wheels, this means that the machine can only be moved by using the drive motors via
the operating panel or the radio control unit