HTP Mod Con 300 HL - Page 30

30
APPROVED PLASTIC CONDENSATE PIPING MATERIAL
MATERIAL
STANDARDS FOR INSTALLATION IN:
UNITED STATES
CANADA
PVC SCHEDULE 40 / 80
ANSI/ASTM D1785
ULC S636
Table 6 – Approved Plastic Condensate Piping Material
APPROVED PIPE CEMENT AND PRIMER FOR PLASTIC PIPE
MATERIAL
STANDARDS FOR INSTALLATION IN:
CEMENT AND PRIMER
UNITED STATES
CANADA
CPVC
ANSI/ASTM F493
ULC S636
PVC
ANSI/ASTM D2564
Table 7 – Approved Pipe Cement and Primer for Plastic Pipe
APPROVED METALLIC EXHAUST VENTING MATERIAL
MATERIAL
STANDARDS FOR INSTALLATION IN:
UNITED STATES
CANADA
AL294C
U.L. LISTED
U.L. LISTED
Table 8 – Approved Metallic Exhaust Venting Material
APPROVED METALLIC INTAKE VENTING MATERIAL
MATERIAL
STANDARDS FOR INSTALLATION IN:
UNITED STATES
CANADA
“B” GAS VENT
U.L. LISTED
U.L. LISTED
GALVANIZED
U.L. LISTED
U.L. LISTED
Table 9 – Approved Metallic Venting Material
APPROVED STAINLESS STEEL VENT ADAPTERS AND TERMINATIONS
Mod Con 300 & 500
HTP PART NUMBER
Boiler Adapter 4”
7250P-732
Horizontal Vent Terminal 4”
7350P-607
Vertical Rain Cap 4”
7350P-609
Mod Con 850
HTP PART NUMBER
Boiler Adapter 6”
7350P-114
Horizontal Vent Terminal 6”
7350P-608
Vertical Rain Cap 6”
7350P-610
Table 10 – Approved Stainless Steel Vent Adapters and Terminations
You must not use “B” vent in an exhaust application. “B” vent is for intake applications ONLY. Using “B”
vent in an exhaust application will result in serious injury or death.
Both exhaust and air intake vents must exit from the same side of the building to assure correct appliance
operation.