66 |
REL T1 timer
The switch-on delay REL T1 delay entered in the process: Setting can be viewed
in this menu item and shows the remaining time from reaching the set setpoint
values until switching.
REL T2 timer
The switch-on delay REL T2 delay entered in the process: Setting can be viewed
in this menu item and shows the remaining time from reaching the set setpoint
values until switching.
REL F1 timer
The switch-on delay REL F1 delay entered in the process: Setting can be viewed
in this menu item and shows the remaining time, from reaching the set setpoint
values, until the switching operation.
REL F2 timer
The switch-on delay REL F2 delay entered in the process: Setting can be viewed
in this menu item and shows the remaining time from reaching the set setpoint
values until switching.
Settings (read only) ...
In this menu item, the settings made can be checked without leaving the control
process „TF switch“. To do this, select the menu item „Settings (read only) ...“
with the OK button. Use the
,
keys to call up and view the settings made.
You can only make changes in the settings process. With the help of the ESC
key, you leave this menu item and return to the control process.
HEATING FUNCTION IN TF-SWITCHING MODE
The „Heating“ function is set if the set switch-on temperature is lower than the
switch-off temperature. The control is carried out by the relay T1 or T2.
Modes/ functions
To Next Page
Loading...
Need help?
General
