| 73
Professional humidity switch PLS1000
9. WARRANTY AND GUARANTEE
The dealer / manufacturer from which the device was purchased provides a
guarantee of 2 years from the date of handover for the material and manufacture
of the device. In the event of a defect, the purchaser is initially only entitled to
supplementary performance. The supplementary performance includes either
the repair or the delivery of a replacement product. Any devices or parts which
have been replaced will become the property of the dealer / manufacturer.
The buyer has to notify the trader of defects immediately. Proof of the warranty
claim shall be furnished by means of a proper purchase confi rmation (purchase
receipt, invoice, if applicable).
Damages resulting from improper handling, improper connection, use of parts
from other manufacturers, normal wear and tear, use of force, personal repair
attempts or changes to the device, cables or terminals, change of circuit,
damage due to ignoring the operating instructions, or improper use or other
external infl uences , if connected to an incorrect voltage or current type,
bridged or incorrect fuses, in case of misuse or damage caused by negligence,
are not covered by the warranty or void the warranty.
Further claims against the vendor due to this warranty obligation, in particular
claims for compensation for loss of profi t, compensation for use and indirect
damages, are excluded, unless legally mandatory.
We reserve the right to repair, rectify, replace or refund the purchase price.
Costs and risks of transport, assembly and disassembly work as well as all other
costs which can be connected with the repair are not replaced. Liability for
consequential damage resulting from faulty function of the device - of whatever
nature - is in principle excluded.
In the following cases, the warranty will expire and the device returned at your
expense:
– In the case of damage caused by improper handling, operation, storage, as
well as by force majeure or other external infl uences.
– In the case of changes of any kind and repair attempts on the device, cables
or clamps.
– When non-original components have been used.
72 |
8. GENERAL INFORMATION
MAINTENANCE
The Professional Humidity Switch PLS 1000 is largely maintenance-free. For
permanent operation, as with any safety-related device, the function must be
checked at intervals that are not dependent on the application. Check the
device for damage before each use! If you fi nd any damage, stop operating
the device and take it to a specialist workshop.
H-TRONIC GmbH cannot be made liable for damages and / or losses of
any kind, such as single or consequential damages resulting from the fact that
connected devices have not functioned and / or switched, despite the detection
of humidity or temperature changes by the Professional Humidity Switch.
CLEANING
First disconnect the device from the mains. Clean the device only with a dry
cloth, this can be slightly moistened if the device is heavily soiled. Do not use
solvent-based cleaning agents for cleaning.
MALFUNCTION
If it can be assumed that safe operation is no longer possible, the device must
be taken out of operation and secured against unintentional operation.
This applies if:
– The device has visible damage
– The device is no longer functional
– Parts of the device are loose
– The connecting cables show visible damage
– The device has obvious transport damage
– After storage under unfavorable conditions.
If the device needs to be repaired, only original spare parts may be used! The
use of alternative spare parts can lead to serious damage and personal injury.
Service and repair work may only be carried out by a specialist or a trained
person under the direction and supervision of a qualifi ed electrician. Should
the device become malfunctioned, we recommend sending it to us for repair.
General information
To Next Page
Loading...
Need help?
General
