Table 4-4 Default data
Name Default Data Description
Initial user name and
password of the MM910
l User name: root
l Password: Huawei12#$
The default user of the
MM910 OS has all OS
rights.
Software
PuTTY.exe is free software. You can download it from the Internet. PuTTY 0.60 or later is
required for login over a serial port.
Procedure
Step 1 Log in to the BMC CLI.
Step 2 Log in to the MM910 WebUI.
For details, see 6.5 Logging In to the MM910 WebUI.
Step 3 On HMM Web, choose Chassis Settings.
The Chassis Settings page is displayed.
Step 4 In the navigation tree on the left, choose Network Settings > Switch Modules.
NOTE
On the HMM WebUI, "Swi" is changed to "Switch Modules" from verion 6.91A.
Step 5 Click Edit.
Edit the IP addresses of management network ports of the converged switching plane in
specific slots.
Step 6 Click Deliver.
The IP addresses of converged switching plane management network ports are successfully
set.
Step 7 (Optional) Configure the switching plane gateway.
1. Use an SSH connection tool to log in to the MM910 CLI by using the floating IP address
of the MM910s.
This topic describes how to use PuTTY to log in over SSH. For details, see Logging In
to a Server Over a Network Port by Using PuTTY.
2. Configure a gateway address for the Ethernet switching plane so that the switching plane
can properly communicate with the PC.
smmset -l swiN:fruM -d route -v targetvalue maskvalue gatewayvalue
The parameters are described as follows:
– N: specifies the slot number of a switch module. Its value ranges from 1 to 4,
mapping to switch module slots 1E, 2X, 3X, and 4E respectively.
– M: indicates the ID of a switching plane. The value of the converged switching
plane is 2.
CX320 Switch Module
User Guide
4 Configuring the CX320
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 57
To Next Page
Loading...
