Figure 4-4 Connection between the local PC and an idle STACK port on an
MM910 stacked
Step 2 Use an SSH connection tool to connect to the IP address of a switching plane to log in to the
CLI of the switching plane.
This topic uses PuTTY as an example for login over SSH. For details, see 6.2 Logging In to
the MM910 CLI Over a Network Port by Using PuTTY.
----End
l Log in to the CLI of a switching plane over SOL.
Step 1 Connect the Ethernet port on the PC to the MGMT port on the active or standby MM910. For
details, see Step 1 in "Log in to the CLI of a switching plane over SSH.".
CX320 Switch Module
User Guide
4 Configuring the CX320
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 61
To Next Page
Loading...
