Huawei CX320 - Page 72

[~HUAWEI-ui-console0] commit
Step 8 Exit the user serial port view.
[~HUAWEI-ui-console0] quit
Step 9 Quit the system view.
[~HUAWEI] quit
Step 10 Save the settings.
<HUAWEI> save
Warning: The current configuration will be written to the device. Continue? [Y/N]:
Enter Y to save the configuration. The following information is displayed:
Now saving the current configuration to the slot 1 .
Info: Save the configuration successfully.
begin synchronize configuration to SMM ...
slot 1: upload configuration to SMM successfully.
<HUAWEI>
----End
l Change the initial password for logging in to the converged switching plane over SSH.
Step 1 On the CLI of the converged switching plane, run the following command to go to the page
for changing a password:
<HUAWEI> local-user change-password
The command output is as follows:
Please enter old password:
Step 2 Enter the old password.
The following information is displayed:
Please enter new password:
Step 3 Enter a new password.
The password is case-sensitive and must meet the following requirements:
l Contain at least two types of the following characters:
– Uppercase letters A to Z
– Lowercase letters a to z
– Digits 0 to 9
– At least one of the following special characters: .`~!@#$%^&*()-_=+\|[{}];:'",<.>/
l Cannot be the same as the user name or the user name in reverse order.
The following information is displayed:
Please confirm new password:
Step 4 Enter the new password again.
If the following information is displayed, the password is successfully changed:
Info: The password is changed successfully.
CX320 Switch Module
User Guide
4 Configuring the CX320
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 66