BIOS Menu (Version: 2.42)
1. Continue to boot
2. Update from serial interface
3. Update from ethernet interface
4. Modify startup parameters
5. File system
6. Modify BIOS password
7. Modify console password
8. Rollback from VRPv8 to VRPv5
9. Reboot
Step 4 Press 6 to go to the page for changing the BIOS password.
The following information is displayed:
Old password:
Step 5 Enter the initial password of BIOS.
The following information is displayed:
password must contain at least two types of characters.
New password:
Step 6 Enter a new BIOS password.
The following information is displayed:
Confirm password:
Step 7 Enter the new password again.
If the following information is displayed, the initial user password is successfully changed.
The password is changed successfully.
----End
l Change the initial password of the BMC.
Step 1 On the CLI of the BMC, run the following commands to go to the page for changing the root
user password:
BMC:/#ipmcset -d password -v root
The command output is as follows:
Input your password:
Step 2 Enter the initial password.
The following information is displayed:
New password:
Step 3 Enter a new password.
The password must meet the following requirements:
l Contain 8 to 20 characters.
l Contain a space or one of the following special characters:
`~!@#$%^&*()-_=+\|[{}];:'",<.>/?
l Contain at least two types of the following characters:
– Uppercase letters A to Z
CX320 Switch Module
User Guide
4 Configuring the CX320
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 68
To Next Page
Loading...
