9
Service Mode Working Method Configuration
IPoA
z Take the HG520b as a router.
z The HG520b uses the static
public IP address to access the
Internet.
z Use the IPoA encapsulation
mode to encapsulate the
packets.
Refer to 3.4
"Configuring
the IPoA
Mode."
RFC2684B
z Take the HG520b as a router.
z Use the static IP address or the
IP address dynamically allocated
by the ISP.
z Use the IPoE/IPoA
encapsulation mode to
encapsulate the packets.
Refer to 3.5
"Configuring
the RFC2684B
Mode."
PPPoE
z Take the HG520b as a router.
z Use the embedded PPPoE
dial-up software of the HG520b
for dialing.
z Use the PPPoE encapsulation
mode to encapsulate the
packets.
Refer to 3.6
"Configuring
the PPPoE
mode."
Note:
ISP = Internet Service Provider
IPoA = Internet Protocol over ATM
PPPoE = PPP over Ethernet
PPPoA = PPP over ATM
Caution:
Some parameters are validated only after they are saved and the
HG520b is rebooted. Follow the prompt in the configuration page to
perform this operation.
To Next Page
Loading...
Need help?
General