13
(3) In the WAN configuration page, select the PVC that needs to
be configured.
(4) Set Mode to Routing and set Encapsulation to PPPoA.
(5) Configure the relevant parameters according to the values in
the
Table 3-3.
(6) Fill in the username and the password (provided by the ISP).
(7) Click Submit.
2. Configuring Your Computer
Configure the network card for your computer, to enable the computer
to automatically obtain information such as the IP address and the
gateway.
3.4 Configuring the IPoA Mode
This section describes the process to configure the HG520b in the
IPoA mode and the process to configure your computer to access the
Internet through the HG520b.
3.4.1 Preparation
Table 3-4 shows the configuration for the IPoA mode.
Table 3-4 Configuration for the IPoA mode
Name Configuration
VPI/VCI Provided by the ISP
Mode Routing
Encapsulation IPoA
IP Address
There are two methods to obtain IP
Address:
z Obtain default gateway automatically
z Use the static IP address
To Next Page
Loading...
Need help?
General