User Manual
6
2. The side panel of the HG556a provides the following interface and button:
z
One Wi-Fi button:
Note for the Wi-Fi button:
The initial configuration for the Wi-Fi function of the HG556a is Enabled. Press
and hold the WiFi button for less than four seconds to disable the WiFi function.
Press and hold the Wi-Fi button for more than four seconds to enable the WPS
function.
More details about the Wi-Fi button, see 2.4 Connecting the PC to the HG556a Through
Wi-Fi
.
z
One USB interface: connects a USB storage device, such as a USB disk, a printer etc.
1.4 Description of the Indicators on the Front and Rear
Panels
Indicator Color Status Meaning
- Off There is no message. Message
Red On There is an incoming message.
- Off The HSPA module is not connected or used.
Red Blinking slowly
The HSPA connection is normal and data
connection is being established.
Red Blinking quickly
The HSPA connection is normal and voice
connection is being established.
HSPA
Red On The connected HSPA module works normally.
- Off The Wi-Fi network is not activated.
Red Blinking slowly
The Wi-Fi Protected Setup (WPS) process is in
progress.
Red On The Wi-Fi connection is in good condition.
Wi-Fi
Red Blinking quickly
The Wi-Fi connection is normal and data is being
transmitted on the link.
- Off The ADSL connection is not activated.
Red Blinking slowly The ADSL connection is in process.
Red On The ADSL connection is in good condition.
DSL
Red Blinking quickly
DSL synchronization is in progress.
- Off The HG556a is powered off. POWER
Red On The HG556a is powered on.
- Off There is no Ethernet connection.
Green On The Ethernet connection is in good condition.
LAN
Red On The LAN connection is not connected.