Huawei Iris Hellas SUN2000 Series - Page 81

Figure 7-13 Power adjustment parameters (special user)
----End
Parameters
No. Parameter Description Remarks
1 Remote power
schedule
If this parameter is set to Enable,
the inverter responds to the
scheduling instruction from the
remote port. If this parameter is
set to Disable, the inverter does
not respond to the scheduling
instruction from the remote port.
-
2 Schedule instruction
valid duration (s)
Species the time for maintaining
the scheduling instruction.
When this parameter is set
to 0, the scheduling
instruction takes eect
permanently.
3 Maximum active
power (kW)
Species the output upper
threshold for the maximum active
power to adapt to dierent market
requirements.
-
4 OFF at 0% power
limit
If this parameter is set to Enable,
the inverter shuts down after
receiving the 0% power limit
command. If this parameter is set
to Disable, the inverter does not
shut down after receiving the 0%
power limit command.
-
SUN2000-(175KTL-H0, 185KTL-INH0, 185KTL-H1
User Manual
7 Man-Machine Interactions
Issue 05 (2020-08-30) Copyright © Huawei Technologies Co., Ltd. 73