Figure 4-6 LC/PC optical connector
The plugging/unplugging of LC/PC optical interface only needs an axial operation instead of a
rotation.
The operation procedures and precautions are as follows:
l Cautiously align the head of the fiber jumper with the optical interface on the optical board
and push in the fiber with proper strength.
l Press the clip before pulling it out. Push in the fiber connector inward slightly, and then
pull out the connector.
4.7.3 Technical Specifications
Table 4-16 shows the technical specifications of the optical fiber.
Table 4-16 Technical specifications of the optical fiber
Item
Description
Fiber transmission mode Single-mode/Multi-mode
Fiber connector 1 LC/PC and SC/PC
Fiber connector 2 LC/PC, SC/PC and FC/PC
Fiber outer diameter 2 mm ( 0.08 in. )
4.8 16xE1 Cable
This section describes the structure and technical specifications of the 16xE1 cable.
4.8.1 Overview
The E1 interface on the NE40E uses 75-ohm or 120-ohm trunk cables. One end of the 16xE1
cable is connected to the E1 electrical interface on the device using the Anea 96 connector; the
other end of the 16xE1 cable is connected to the Digital Distribution Frame (DDF) using a
connector that needs to be made as required on site.
HUAWEI NE40E-X1 & NE40E-X2 Universal Service
Router
Hardware Description 4 Cables
Issue 02 (2011-09-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
85
To Next Page
Loading...
Need help?
General
