Huawei OceanStor V3 Series - Page 84

Figure 4-2 Diagram of central backup and disaster recovery
Site B
Primary
storage system
Site A
Switch
Maintenance
terminal
Management
network port
Controller A
host port P0
Controller B
host port P0
Application
server 1
Standby
server
Secondary
storage system
Switch
Maintenance
terminal
Management
network port
Controller A
host port P0
Site C
Controller B
host port P0
To achieve data backup to the central backup site, an iSCSI connection between site A and
site B must be set up first, and then a logical connection needs to be established by adding a
route and a target. Before setting up the connections, a detailed networking plan must be
drawn.
Table 4-5 describes the IP address plan for site B.
Table 4-5 IP address plan for site B
Port
IP Address Subnet Mask Gateway
Management network
port
192.168.19.10 255.255.0.0 192.168.0.1
Host port P0 on
controller A
172.17.20.31 255.255.0.0 172.17.0.1
Host port P0 on
controller B
172.17.20.32 255.255.0.0 172.17.0.1
Service Planning
Based on the conclusion of the requirement analysis, a central disaster backup solution can
meet the requirements of the carrier. Figure 4-3 shows the configuration roadmap of the
solution.
OceanStor V3 Series
Remote Replication Feature Guide for Block
4 Configuration Example
Issue 06 (2018-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76