Step 3 Set up a logical connection between sites A and B.
1. Configure host port IP addresses.
This step is fundamental for setting up a logical connection between the two storage
systems. The following uses port CTE0.R5.IOM0.P0 on the primary storage system at
site A as an example to describe how to configure a port IP address. The procedure for
any other host port on either site is the same.
In the navigation tree, click
Provisioning. Click Port, and click the host port
whose IP address you want to change. Click Properties. On the Properties of the Port
dialog box, configure the IP address of the port.
OceanStor V3 Series
Remote Replication Feature Guide for Block
4 Configuration Example
Issue 06 (2018-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
86
To Next Page
Loading...
