PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Copyright © Huawei Technologies Co., Ltd.
7.2 Installing the Communications Cables
7.2.1 IP Networking
Procedure
Step 1 Install a communications cable.
1. Connect one end of a communications cable to the FE port on the SMU02S.
2. Connect the other end to the network access device.
Figure 7-2 Installing a communications cable
Step 2 Install a communications cable (in a parallel scenario).
1. Connect one end of the cable to the POE3 port of the smart ETH gateway.
2. Connect the other end to the network access device.
Figure 7-3 Installing the communications cable
Step 3 Cover a PVC corrugated pipe over the cable parts outside the cabinet and secure the PVC
corrugated pipe to the cable hole.
----End
To Next Page
Loading...
