PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Copyright © Huawei Technologies Co., Ltd.
Step 5 Route the cables according to the rules, and bind the cables with cable ties.
Step 6 Fit the cables protruding from the cabinet with a PVC corrugated pipe. Secure the pipe to the
cable outlet.
----End
7.8 Installing a Battery Temperature Sensor
Prerequisites
If the site requires a battery temperature sensor, perform the following steps to install it.
Procedure
Step 1 Install a battery temperature sensor in the middle position for the battery on the second layer
(count from the bottom up in the battery compartment) and bind it using a cable tie, as shown
in the following figure.
Avoid direct exposure of a battery temperature sensor to sunlight or direct contact with a
heat source, cold source, air vent, or air conditioner vent.
The battery temperature sensor probe must not be in direct contact with a metal surface.
Figure 7-20 Securing a battery temperature sensor
To Next Page
Loading...
