Huawei Quidway S5600 Series - Page 55

Installation Manual
Quidway S5600 Series Ethernet Switches Chapter 4
Starting up the Switch at the Initial Boot
Huawei Technologies Proprietary
4-6
....................................................OK!
Starting at 0x80020000...
Initialize:
LSH1LTSU...................................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
Press ENTER to get started.
The appearance of “Press ENTER to get started” indicates that the switch has
completed its boot.
Press <Enter>; the system displays:
<Quidway>
You can configure the switch now.
 Note:
A wide range of command views are available for Quidway Series Switches. For more
information on configuration commands and command line interfaces, refer to Quidway
S5600 Series Ethernet Switches Operation Manual and Quidway S5600 Series
Ethernet Switches Command Manual.