Huawei Quidway S5600 Series - Booting the Switch; Verifying Installation before Power-Up; Powering up the Switch

Installation Manual
Quidway S5600 Series Ethernet Switches Chapter 4
Starting up the Switch at the Initial Boot
Huawei Technologies Proprietary
4-5
4.4 Booting the Switch
4.4.1 Verifying Installation before Power-up
Before powering up the switch, check that:
z Both the power cord and the grounding wire are correctly connected.
z Proper power supply is used.
z The console cable is correctly connected.
z The console terminal (or PC) has been started and the related parameters have
been set on it.
4.4.2 Powering up the Switch
Starting......
***********************************************************
* *
* Quidway S5600 BOOTROM, Version 318 *
* *
***********************************************************
Copyright (c) 1998-2005 Huawei Technologies Co., Ltd.
Creation date : Dec 20 2005, 15:52:47
CPU type : BCM1122
CPU Clock Speed : 400MHz
BUS Clock Speed : 33MHz
Memory Size : 128MB
Mac Address : 00e0fc005600
Press Ctrl-B to enter Boot Menu... 5
The last line queries that whether you want to enter the Boot Menu and waits for you for
five seconds:
z To enter Boot Menu, press <Ctrl+B> within five seconds
z If no <Ctrl+B> input in five seconds, the system will boot automatically
The following is the system auto-booting interface:
Auto-booting...
Decompress
Image...............................................................
....................................................................
....................................................................
....................................................................
....................................................................