Huawei Quidway S5600 Series - Page 63

Installation Manual
Quidway S5600 Series Ethernet Switches Chapter 5
Loading Boot ROM and Host Software
Huawei Technologies Proprietary
5-8
Caution:
TFTP Server program is not provided with the Quidway Series Switches.
Step 3: Run terminal emulation program on the PC that is connected to the console port.
Start the switch, access the Boot Menu, and then enter the download protocol menu.
To download the Boot ROM program, enter <6> or <Ctrl + U> to access the menu for
Boot ROM downloading when the system displays: “Enter your choice(0-9):”
Enter your choice(0-9):
Please set bootrom download protocol parameter:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Step 4: In the download protocol menu, press <1>to select TFTP protocol to download
Boot ROM or host software. Press <Enter>. The system displays the following
information:
Load File name
Switch IP address ←(This address and the server IP address must be on the same
network segment)
Server IP address ← (IP address of the PC where the file is stored)
Step 5: Input the TFTP parameter values and press <Enter>. The system displays the
following information:
Are you sure to update your bootrom?Yes or No(Y/N)
Step 6: Press <Y> to start file downloading and <N> to return to the program
downloading menu. Suppose you press <Y> and then <Enter>. The system starts Boot
ROM program downloading and automatically starts Boot ROM loading. After finishing
loading, it displays the following information:
Initializing net....done!
Loading.........................done!
Bootrom is updating now.....................................done!
III. Loading host software
Follow these steps to download host software of the switch.
Step 1: Select <1> in the Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter