14
4. (Optional) Remove the Smart Dongle for future use.
Communications port (COM)
Removing SUN2000-(8KTL–20KTL)-M0
1. (Optional) Open the anti-theft lock.
2. Remove the SUN2000 from the mounting bracket.
Loosen the nuts, flat washers, and spring washers of the two expansion bolts below.
6. Remove the PE cable and remove the crimped OT terminal. Set the cable aside for future use.
5. Remove the signal cable connector for future use.
•
This section describes how to remove a WLAN-FE Smart
Dongle.
•
The 4G Smart Dongle and WLAN Smart Dongle can be
removed similarly.
Smart Dongle port (GPRS/4G/WLAN)
Expansion
bolt
To Next Page
Loading...
