If there are two or more sites displayed in the list, users can choose one to make a call, as
shown in Figure 5-2.
Figure 5-2 Voice dialing list
5.2 SiteCall
SiteCall is a unique conference function provided by Huawei. It allows users to define
conferences and participants on the endpoint, making it simple to initiate a multi-party
conference. Users can create conferences using the touch panel, web interface, or remote
control of the endpoint. After setting conference parameters (such as the conference name,
data rate, and number of sites), the users can start the conference. The endpoint can initiate
conferences through H.323 or SIP.
5.3 P2P to Multipoint
When the endpoint is connected to an MCU, you can turn a P2P call into a multipoint call,
increasing conference efficiency. Below are different scenarios where this may be necessary.
Local Site Receiving Calls from Other Sites
If two sites are having a P2P call and one of the sites receives another incoming call (or
multiple incoming calls), that site can perform one of the following operations:
l Answer&Merge: Answer calls from other sites and turn the P2P call into a multipoint
conference.
l Answer&Hold: Answer calls from other sites and place the original P2P call on hold.
Then you can place calls on hold or merge calls as follows:
TE30 Videoconferencing Endpoint
Product Overview
5 Functions and Features
Issue 03 (2018-06-30) Copyright © Huawei Technologies Co., Ltd. 15
To Next Page
Loading...
Need help?
General
