HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
4 Display Device and Camera
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Specifies the resolution for each video
output port. The available options vary
depending on your settings of Output
mode. Table 4-4, Table 4-5, and Table
4-6 list the resolutions supported by the
video output ports in each output mode.
The default value for the
2 SD OUT port (only
TE80) is NTSC.
The default value for other
ports is 1080p.
Specifies the video refresh rate. The
available options vary depending on your
settings of Video resolution. Table 4-7
lists the refresh rates available for each
video resolution.
The default value is 60Hz.
Specifies how to adjust the aspect ratio to
fit the video into the screen.
Stretch: The aspect ratio is
changeable.
No stretch: The aspect ratio is not
changeable.
Intelligent stretch: Your endpoint
crops the video to an appropriate size
and stretches the video to full screen
with the original aspect ratio. For
example, to change a wide-screen
video to a narrow-screen video, your
endpoint crops the left and right edges
of the wide-screen video and stretches
the video to till the screen.
The default value is
Stretch.
Specifies how your endpoint displays the
video and presentation.
NOTE
Only the main output port supports this
parameter.
Full screen: Your endpoint displays
the video or presentation in full screen
in the following priority sequence:
remote presentation, local
presentation, remote video, and local
video.
PiP: The Picture in Picture (PiP)
function is enabled to display the
video and presentation.
2 panes: The video and presentation
are displayed in two panes.
3 panes (a) or 3 panes (b): The video
and presentation are displayed in three
panes.
The default value is Full
screen.
Specifies the position of the PiP window
The default value is Lower
To Next Page
Loading...
