Huawei WA603DE - Page 10

WA603DE & WA653DE
Fat AP Configuration Guide 2 Basic Configuration
Issue 02 (2012-04-19) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
5
2. Configure common parameters according to Table 2-1.
Table 2-1 Description of common parameters
Parameter Description
Radio Network Name of the wireless network. The name cannot exceed 32 characters.
The default name is Radio 2.4G or Radio 5G.
Wireless Mode Wireless mode. A single-frequency AP can only use 2.4 GHz, and
dual-frequency AP can use either 2.4 GHz or 5 GHz.
Channel Wireless channel. Select SmartSelect or any channel.
Channel Width Channel bandwidth. Select 20 MHz or 40 MHz.
Country Code Name of the country where the AP is used.
AeroScout RFID
tag detection
Whether to detect the AeroScout RFID tag. To detect the tag, select
Enabled. By default, Disabled is selected.
3. (Optional) Click Edit Common Settings in the Advanced Settings area and configure the
parameters as shown in Figure 2-3 according to Table 2-2.
Figure 2-3 Configuring advanced parameters
Table 2-2 Description of advanced parameters
Parameter Description
Transmit Power Transmit power of wireless signals. The options are as follows:
z
Full: full transmission power
z
Half: half of the transmission power
z
Quarter: a quarter of the transmission power
z
Eighth: eighth of the transmission power
z
Minimum: minimum power
The default value is Full.