WA603DE & WA653DE
Fat AP Configuration Guide 4 Upgrade and Maintenance
Issue 02 (2012-04-19) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
26
Figure 4-5 Enabling the system log function
Table 4-2 describes the log parameters.
Table 4-2 Description of the log parameters
Parameter Description
Log Status Enable the system log function, which is enabled by default.
Syslog Server Address IP address or host name of the system log server. The default
value is 0.0.0.0.
Syslog Server Port UDP port used by the system log server. The value is 514 or
ranges from 11024 or 65535. The default value is 514.
2. Select Enable in the Log Status field.
Table 4-3 describes the fields in an event log.
Table 4-3 Fields in an event log
Parameter Description
Log time Time when the log is generated.
Device name Device name of the AP.
Log information Content of the log.
3. Enter the IP address of the system log server and retain the default port setting.
4. Click Update Settings to save the settings.
----End
To Next Page
Loading...
