3. Press either one of the two power Midgate
®
latch release buttons. The Midgate
®
will move
slightly forward from its closed position.
The latch release buttons operate while the
ignition is in RUN, ACCESSORY, in RAP
mode, or up to ten minutes after removing
the key. If necessary, press the global
express-down button to reactivate the release
buttons for an additional ten minutes.
4. Pull the Midgate
®
inward and down to its fully
lowered position.
5. Flip the auxiliary panel on the top of the
Midgate
®
into position to bridge the gap
created by the hinges in the Midgate
®
.
There are two finger holds on the panel.
Raising the Midgate
®
To raise the Midgate
®
, do the following:
1. Fold the auxiliary panel back into the exterior
of the Midgate
®
. The panel should snap loudly
back into position which means it is secure.
2. Reverse the steps for lowering the Midgate
®
listed previously. The Midgate
®
must be fully
latched on both sides before the window
can be raised.
3. Press the top part of the Midgate
®
window
switch to express-up the window. To stop
the window, press the switch a second time.
107
To Next Page
Loading...
