INSTALLATION
6
Attach the installation or extension brackets using the screws provided.
IMPORTANT: The front edges of the installation brackets must be level and aligned to
each other.
If using spacer blocks, first attach the installation bracket to the
1
⁄
2
" spacer block before stacking additional spacer blocks together.
Insert the legs of the installation bracket into the tabs on the
spacer block.
Then rotate the installation bracket back.
Attach the spacer block(s) and installation
bracket to a flat vertical mounting surface with
a #6 mounting screw long enough for a secure
installation.
A maximum of 1
1
⁄
2
" of spacer blocks per
installation bracket is recommended.
The top of the spacer blocks should be at the
desired shade height.
IMPORTANT: The front edges of the installation
brackets must be level and aligned to each other.
CAUTION: Use drywall anchors when mounting
into drywall.
If using extension brackets, attach an installation
bracket to the underside of each extension bracket
using the provided screws and speed nuts.
Proceed to “Install the Shade” on page8.
Tab
Longer Screw
(Not Provided)
1
1
∕
2
"
To Next Page
Loading...
Need help?
General
