16
Mounting Sensors DSP700 Series Wireless Wheel Alignment Sensors
CAUTION: When mounting sensors to the wheel adaptors, the sensor shaft
must be fully seated. Make certain that there is no play or
looseness between the sensor shaft and the wheel adaptor.
Rotate the wheel while holding the sensor. Listen and feel for
movement between the sensor and wheel adaptor. Runout
compensation and alignment accuracy will be adversely affected
if there is any movement between the sensor and wheel adaptor.
Sensors must fit tightly against the surface of the wheel adaptor
or the lock may not hold. This could allow the sensor to fall and
be damaged.
2.2 Mounting Wheel Adaptors onto Wheels
Typical Installation (Grasping the Outside of Rim Lip)
NOTE: Rim studs are reversible. Use the spade end that best fits the
rim. The two wheel adaptors on the front wheels or back wheels
need to be uniform with same end of the rim studs engaged onto
the rim.
Position the wheel adaptor with the two upper external rim studs on the outside of the
wheel rim.
Align the two lower external rim studs on the outside of the wheel rim and check that all
four rim studs will engage the outside of the wheel rim.
Turn the adaptor adjustment knob clockwise to firmly attach the adaptor to the wheel.
Test the security of the installation by lightly tugging on the wheel adaptor.
CAUTION: Do not allow the rim studs to slip on the wheel. Runout
compensation and alignment accuracy will be adversely affected
if the wheel adaptor is allowed to slip on the wheel.
To Next Page
Loading...
