Need help?Do you have a question about the Hunter Soil-Clik and is the answer not in the manual?
General| Type | Soil Moisture Sensor |
|---|---|
| Moisture Measurement Range | Adjustable |
| Adjustable Sensitivity | Yes |
| Compatibility | Hunter controllers |
| Power Source | Controller-powered |
| Operating Temperature | 0°C to 60°C (32°F to 140°F) |
| Wiring | 2-wire |
| Installation | near root zone |
| Function | Interrupts irrigation when soil moisture reaches desired level |
Select the best area and zone for the probe based on drying patterns and irrigation sequence.
Identify the fastest-drying area and place the probe in the root zone for accurate readings.
Steps for preparing and inserting the Soil-Clik probe into the soil, including soaking and hole creation.
How to set the desired soil moisture level using the module's buttons and display.
Understanding alarm symbols indicating malfunctions and the need to replace the module.
Common issues like plants being too dry or wet, and their corresponding troubleshooting steps.
To Next Page
