4
Installation
Choose a zone with full sun exposure that is
in the fastest-drying area of the landscape. If
necessary, move valve wires so that this is the
last (highest-numbered) station to water.
Choosing the Probe Location
The moisture-sensing Soil-Clik probe must be installed
within 1,000' (300 m) of the Soil-Clik module, using
18 AWG (1 mm
2
) direct burial (UF) wire.
Choosing the Zone
Install the probe within the last typical zone to irrigate,
so that normal irrigation will not interrupt watering
prematurely.
1,000' (300 m)
To Next Page
Loading...
