Hunter DSP700 Series - Mounting Sensors; Mounting Sensors onto Wheel Adaptors

DSP700 Series Wireless Wheel Alignment Sensors Mounting Sensors
•
13
2. Mounting Sensors
2.1 Mounting Sensors onto Wheel Adaptors
NOTE: For DSP706 sensors, sensor toe arm position is reversible. Toe
arms may be mounted on the front or rear wheels to allow for
clearance of air dams, mud flaps, etc.
Sensors may be mounted on the wheel adaptors before mounting the wheel adaptors on
the vehicle. In some cases, it may be easier to mount the wheel adaptor first and then
mount the sensor onto the adaptor. Either method may be used.
If detached, attach the sensor to the wheel adaptor by inserting the sensor mounting
shaft (at the rear of the sensor) into the sensor shaft mounting hole in the middle of the
center casting.