Need help?Do you have a question about the Hunter DSP9100 and is the answer not in the manual?
Resets all setup items to factory defaults, stored in EEPROM.
Tests motor functionality by adjusting duty cycle for clockwise/counter-clockwise rotation.
Repeats balance spins automatically with adjustable delay between spins.
Verifies functionality of all keys and switches by requiring input for each.
Activates all LEDs and tests display segments until spindle rotation or hood switch changes.
Procedure for safely removing and replacing the EPROM chip for software updates.
Allows calibration of only the outer Dataset arm, skipping the inner arm calibration process.
Attaches calibration weight and spins to check readiness or identify errors.
Initiates the primary balancer calibration process using calibration weights.
Detailed steps for calibrating the inner Dataset arm using a specific calibration tool.
Detailed steps for calibrating the outer Dataset arm using a specific calibration tool.
Configures the inflation station and selects pressure units (kPa, PSI, Bar).
Calibrates the inflation station, including zeroing pressure and optional reference gauge calibration.
Interprets status bits indicating the success or failure of each stage of the spin calibration.
Interprets status bits related to the inner Dataset arm calibration steps and sensor readings.
Interprets status bits related to the outer Dataset arm calibration steps and sensor readings.
To Next Page
General