• You can start by programming 3 different start times for program A.
• Press the mode button until the arrow is flashing next to start times. It shows start time one
of program A.
• We advise 3 starting times for example 9.30, 13.00 and 16.30 hours (most common).
• We're going to set the first start time at 9.30 a.m. Then use the plus (+) button to set the
second time which is 13.00 and then use the plus (+) button again to set the third starting
time which is 16.30.
• We advise 2 minutes run time each for a fishtank and 5 minutes each for a fish unit.
• The fourth potential starting time can be left OFF.
• Keep in mind that the time is depending on the water hardness and the water pressure. If
you have any doubts about the starting times, don’t hestitate to contact us. We are happy to
help you with choosing the optimal settings for your store.
Set runtimes for each of the stations
• Press the mode button until the arrow is flashing next to run time.
• For station 1 you can program 2 minutes. Use the right arrow to go to station 2 to also
program 2 minutes. Use the right arrow to go to station 3 and do the same.
How to set the day for the (automatic) water change
• Press the mode button until the arrow is pointing next to watering days. Program it to water
every day.
• To activate a day, press the plus (+) button and it will switch to the following day. Do this till
you have finished it for the whole week. When you have set all days of the week you will
return to Monday (flashing). Now you’re ready to start with the Automatic Watering System.
To Previous Page
Loading...
Need help?
General
